Skip to main content

Device shows Not filtering

Not filtering means lookups from the device aren't going through Zaksha, so nothing is blocked on it. Open the device in your Zaksha app: the line under Not filtering says why. Find that line below.

"Switched off on the device"​

Zaksha was turned off on the device itself.

  • iPhone: in Settings, search "VPN", open VPN & Device Management, tap DNS and choose Zaksha Filtering.
  • Android: open the Zaksha app on the phone and follow what it shows, or run setup again from Help me configure. Check that Always-on VPN is on.
  • Windows, Mac or Linux: run the setup again from the device's page in your app.

Then follow Check a block works. To stop it happening again, see Tamper lock and alerts.

"Screen Time access off"​

On an iPhone set up as Locked, Zaksha uses Screen Time to pause apps if filtering is switched off. The line reads "Screen Time access off · apps can't be paused".

  1. On the iPhone, open Settings, then Screen Time, then Apps with Screen Time Access, and turn on Zaksha.
  2. If Screen Time itself is off, turn it on. Then open the Zaksha app, tap Allow, then Continue, and confirm with Face ID or the passcode.

"Another VPN is on"​

Another VPN app on the device is sending its traffic around Zaksha. Turn that VPN off. Zaksha is bypassed until you do.

"No traffic through Zaksha"​

Zaksha is set up, but the device's lookups aren't reaching it.

  1. Turn off any other VPN app.
  2. In Chrome or Edge, turn off Use secure DNS, or set it to your current service provider. See Browser skips Zaksha.
  3. Check that Bypass tools is Blocked on the device's page in your app.
  4. Follow Check a block works.

"Zaksha profile removed"​

The Zaksha profile was removed from the Mac or iPhone. Install it again: see Mac or iPhone and iPad.

"Windows 10 isn't supported"​

Zaksha needs Windows 11. See Windows.

"Not connected yet"​

A new device shows Offline with "Not connected yet" until its first lookup reaches Zaksha. This doesn't change by itself over time. If it still says this a few minutes after you finish setup, go back through the steps for the device in Set up a device. A skipped step is the usual cause.

iPhone says Private Relay is "not allowed on this network"​

This is expected on a phone Zaksha filters. iCloud Private Relay would let sites slip past the filter, so Zaksha tells the iPhone not to use it.

  1. Leave Private Relay off on your child's iPhone. Nothing else is wrong.
  2. If the iPhone offers to continue without Private Relay, accept. Sites open as normal.
  3. To switch it off for good: Settings, tap the name at the top, then iCloud, Private Relay, Off.

Still stuck? Ask a question, or message us on WhatsApp. We reply within 24 hours.